The best concrete paint or stain conceals discolorations and signs of damage while providing a protective coating that extends the life of the surface.
Can you paint over a concrete sealer.
There aren t any pores in the concrete for the paint to absorb into and stick to the concrete.
Unless the acetone dye was not properly applied an acetone dyed floor will have a sealer to protect it.
Read our five step guide from prepping to painting to how to seal concrete so all your hard work lasts.
However drylok cannot be used over an oil or latex based paint on the inside of a building.
Concrete outdoor surfaces can face a lot of wear and tear over time but a fresh coat of paint can provide a welcome makeover.
Remove all of the furniture from the room or area that you will.
You don t state exactly what product you used to seal your concrete.
As long as water continues to bead on the surface any paint or stain product will not bond to that surface and failure can be expected.
This is where a little homework will help a lot.
Since epoxy paint is sold as two disparate stable ingredients that are then mixed into a temporarily usable paint preparation is needed at this stage as well since once mixed the paint should be used immediately.
Concrete sealant is available in matte and glossy finishes giving you a choice of adding a smooth or shiny coat on top of the paint.
Drylok may be used over any other cementitious type waterproofing paint in good repaintable condition either inside or outside.
They have all been filled with the primer paint and sealer you have already applied.
If this is the case you may just have to wait until the product wears off.
You can t apply paint over an acrylic concrete sealer and expect it to bond for very long.
Many sealers contain silicones which penetrate into the surface.
You can paint over the sealer but will get better results if you remove it.
Painting concrete is easier said than done you can t just pour a can of paint over your concrete floor and expect it to come out perfectly.
3 key steps to a concrete floor refresh a fresh coat of color solves everything.
Make sure you have selected a pigment that works with the sealer you are using.
For example if you take a universal color and try to stick it into a solvent based acrylic it will not mix.
A tough strong surface like concrete is best covered with a specialized variety such as a coat of epoxy paint.
As with any additive you have to worry about harming the integrity of the sealer.